![]() This will cause soot to come off of the flame, as well as more poisonous Carbon Monoxide. ![]() If the fuel is thicker, the cotton will struggle to do it's job, the top of the wick will dry out and the flame will then start burning the wick instead of the fuel. Viscosity: The Thickness of the liquid does matter as well, proper Kerosene and Lamp Oil need to be very thin for the cotton wick to carry the fuel to the flame fast enough. Fuels around 145 to 175 Degrees F should suffice. Note: Center Draft Oil Lamps often warm the oil more in usual operation and thus we suggest a slightly higher flashpoint fuel for these lamps if a lamp shows signs of acting as a runaway with any approved fuel listed above. You can also bury the lantern in dirt or sand to kill airflow. If a lantern ever has a flame which you can not control, immediately place a bucket over the lantern to kill off the oxygen supply to the lantern. ![]() This is why using the correct fuel is VERY IMPORTANT.ĭangerous Fuels Include: Gasoline, Coleman Fuel, White Gas, Paint Thinner, Mineral Sprits, Wood Alcohol, Naphtha, Turpentine, Benzene and any other fuel with a flash point under 124 degrees F. This will either cause a blow torch affect, and adjusting the wick will not fix the issue, or the flame could simply ignite the fuel in the tank and cause an explosion. This is a critical measurement, if the fuel you have has too low of a flashpoint, the fuel in the tank can heat up past the flashpoint and create enough vapor in the oil tank that will ignite from the flame. Tiki® Brand Citronella Torch Fuel ( OUTDOOR USE ONLY, cut 50:50 with kerosene to extend wick life.) Flash Point: 145 Degrees Fahrenheitįlashpoint: The Temperature at which the fuel will give off enough vapors that they can be lit in air. Crown® Citronella Torch and Lamp Fuel (#CTLP01, #CTLP02, #CTLP48) ( OUTDOOR USE ONLY, cut 50:50 with kerosene to extend wick life.) Flash Point: 141 Degrees FahrenheitĤ. Coleman® Brand Kerosene Fuel (#3000000270) Flash Point: 130 Degrees Fahrenheitģ. Non-Dyed (Clear) Kerosene with a Flash Point Between 124 and 150 Degrees FahrenheitĢ. The approved fuels for outdoor use in Tubular Lanterns and Flat Wick Oil Lamps are:ġ. and #MVP73201, 32 oz., Sold by Wal-Mart ) Flash Point: 142 Degrees Fahrenheit (Purchase only the clear unscented version of this fuel.) MVP Group International Florasense® Brand Lamp Oil (#MVP73200, 64oz. Genuine Aladdin® Brand Lamp Oil (#17552, 32 oz., and #17554, 128 oz.) Flash Point: 141 Degrees FahrenheitĤ. Klean-Heat® Kerosene Substitute (#GKKH99991, 128oz, sold by Home Depot SKU #391-171) Flash Point: 145 Degrees Fahrenheit (Do Not Purchase Klean-Strip 1-K "Kerosene")ģ. The approved fuels for indoor or outdoor use in Tubular Lanterns and Flat Wick Oil Lamps are:ġ. If you are curious if a fuel you have is correct to use, please review the 3 major criteria. The more complicated answer explains the 3 things to look for in a fuel. ![]() ![]() The easy answer is to follow the list of approved fuels found below. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |